Tidal Pull Specifications
- The Length of a Tidal Pull can be tailored to your liking.
- The Back of the pull is a standard height of ¾.
- The Return is a standard depth of 1 3/8”, enough to allow for a standard cabinet or drawer facing of ¾” plus finger room.
The Face Comes in Three Different Styles
Measuring Instructions
Please take the following measurement details into consideration when measuring for your custom made pulls:
- Drawer pulls can be ordered to any length specification without interference issues.
- For cabinets, if you would like your pulls to extend the entire length of the horizontal portion of the cabinet face, you must ensure there is at least a 3/4” space on the cabinet base adjacent to the face that you are measuring to allow space for the cabinet to open completely without interference from the pull.This interference is not an issue if you are installing the pulls on the vertical portion of the cabinet face or if the cabinet pull will not extend the entire length of the cabinet face.
- If the base of your cabinet does not have the necessary spacing between cabinet facings, you must order pulls that are slightly shorter than the full length of your cabinet.
- After measuring, please click here to order.







